Modelling and Simulation of Fouling in a Shell-and-Tube Heat Exchanger for Performance Improvement: An ANSYS Based Case Study

Volume: 2, Issue: 4 (Oct-Dec 2026) MSI Journal of AI and Technology

Authors: Francis Chimobi Akpa, Prof. C. V. Ossia

Abstract

Fouling on heat transfer surfaces lowers the thermal efficiency of shell-andtube heat exchangers, increases energy consumption and causes unplanned shutdowns in oil and gas processing. This study modelled and simulated fouling in a horizontal BEMtype shell-and-tube exchanger (TEMA standard, 64 stainless-steel tubes) that cools a hydrocarbon stream with water at an oil and gas facility in Bonny Island, Nigeria. The exchanger was modelled and its steady-state operation simulated in ANSYS 14.0 using the facility’s design and operating data. Fouling behaviour was assessed over twelve simulated monthly cases, with fouling resistance (Rf) calculated from the clean and fouled overall heat transfer coefficients. In the first month, fouling reduced heat duty by 36.25% relative to the clean exchanger and the overall heat transfer coefficient (U) fell from 26.26–27.02 to 16.15 W/m²·°C. Over the twelve cases, Rf rose from 0.0238 to 0.0264 m²·°C/W while U fell to 15.24 W/m²·°C. Regression showed that Rf was strongly related to U (power law, R² = 0.986), time (power law, R² = 0.951) and mass flow rate (logarithmic, R² = 0.902), and more weakly to log mean temperature difference (linear, R² = 0.777). Because mass flow rate and time were varied together, their effects could not be separated. The relationships offer a simple basis for forecasting fouling growth and planning cleaning, but they are model-based and require validation against measured plant data.

Keywords: Fouling; Shell-and-tube heat exchanger; ANSYS; Heat Transfer Performance; Fouling Resistance; Regression Modelling

Download PDF